SIIG PCI-1S+DOS Manuel d'utilisateur

1CyberSerial PCIQuick Installation Guide04-0388AIntroducing the CyberSerial PCIThe CyberSerial PCI high-speed serial I/O card providesone additional 9

103. Click the down arrow that is next to the COM Portnumber box and select a COM port that is not in use.Click OK.4. Click OK, then close Device Mana

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers!Simply visit our website at www.siig.com and click on Support.Our online

CyberSerial PCI is a trademark of SIIG, Inc.SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows areregistered trademarks

2Package Contents• CyberSerial PCI board• Driver CD• Low profile bracket (Dual Profile board only)• Quick installation guideLayoutJP1Serial Port(9-pin

3Hardware InstallationGeneral instructions for installing the card are providedbelow, since the design of computer cases andmotherboards vary. Refer t

4Driver InstallationThis section provides information on how to install theCyberSerial PCI drivers.DOS1. Boot up DOS and insert the driver CD.2. Copy

53. Select Specify a location, uncheck the other boxes,insert the driver CD, type in D:\9x, then click Next.(Change D: to match your CD-ROM drive lett

6Windows NT 4.01. From the desktop click Start, then Run.2. Insert the driver CD, type inD:\NT4\install_serial.exe, then click OK.(Change D: to match

7Windows XP1. At the Found New Hardware Wizard, choose Installfrom a list or specific location (Advanced), thenclick Next.2. Insert the driver CD, che

8To Verify Windows 2000/XP/2003 Installation1. Right click My Computer, click Manage, then selectDevice Manager.2. Click on the + (plus sign) in front

94. Edit the startup file and add this command line atend of the startup file.- setserial /dev/ttyS2 port 0xa000 irq 9 uart 16950.Note: ttyS value, I/