SIIG SC-SA0R11-S1 Guide d'installation télécharger pdf (Page 11)

11

6. Press F10 to exit the BIOS. When asked Do

you want to exit from Marvell BIOS Setup?

press Y to exit and reboot.

Rebuilding a Failed Mirror Set

When a failure to one member occurs, you will be

notified by the RAID BIOS during boot up. The

steps below will guide you in rebuilding a failed

mirror set.

1. Replace the failed drive with one of equal or

greater capacity, then boot the computer.

2. As the BIOS boots press Ctrl+M when

prompted to enter the RAID BIOS.

3. Select New_VD, press Enter. Select Rebuild

then press Enter.

4. Select the new hard drive under Free

Physical Disks.

5. Press Spacebar to select hard drive, then

press Enter.

6. When asked Do you want to rebuild with

selected physical disk on this vd?, press Y

to select Yes. The mirror will begin

rebuilding. Do not interfere with the process

until completion.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire