SIIG SC-SA0S11-S1 Guide d'installation télécharger pdf (Page 9)

9

Rebuilding a Failed Mirror Set

When a failure to one member occurs, you will be

notified by the RAID BIOS during boot up. The

steps below will guide you in rebuilding a failed

mirror set.

1. Replace the failed drive with one of equal or

greater capacity, then power on the

computer.

2. As the BIOS boots press Ctrl+M when

prompted to enter the RAID BIOS.

3. Select New_VD, press Enter. Select Rebuild

then press Enter.

4. Select new hard drive under Free Physical

Disks.

5. Press Spacebar to select hard drive, then

press Enter.

Deleting RAID Arrays

Deleting RAID arrays will destroy all data on the

disk. Please backup your data before preceeding.

1. As the BIOS boots press Ctrl+M when

prompted to enter the RAID BIOS.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Commentaires sur ces manuels

Pas de commentaire