SIIG SC-SA0312-S1 Guide d'installation télécharger pdf (Page 3)

Hardware Installation

1. Make sure the SATA connectors are in alignment.

Gently insert the SATA hard drive into the SATA

drive slot.

2. Plug the included switching power adapter into

the Cool SATA to USB 2.0/eSATA Docking power

adapter jack, then plug the switching power adapter

into a reliable power source.

3. Use either the USB 2.0 cable OR eSATA cable to

plug the Cool SATA to USB 2.0/eSATA Docking into

the computer.

Note: Do not connect the USB 2.0 cable and eSATA

cable at the same time.

4. Switch on the Cool SATA to USB 2.0/eSATA Docking,

make sure that the 3 blue Power LEDs are lit.

Note: Do not insert or remove a hard drive when

the unit is powered on.

Go to Driver Installation below to complete the

installation.

Driver Installation

Windows and Mac operating systems will automatically

detect and install drivers for the Cool SATA to USB 2.0/

eSATA Docking. No additional driver installation is

needed.

Note: In order to get high speed USB 2.0 performance,

make sure your USB 2.0 controller has the correct drivers

installed.

1 2 3 4 5 6 7 8

Pas de commentaire

SIIG SC-SA0312-S1 Guide d'installation Page 3