SIIG Serial ATA 4-Channel RAID Guide d'installation télécharger pdf (Page 20)

Mirror rebuild on its own. This should happen only once

and it's done automatically. Please do not interfere this

process by re-configuring the RAID sets.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft's Windows XP installation

procedure.

3. Restart the computer when prompted by Windows'

installation.

4. At the Windows Setup screen, press F6 to install the

driver.

5. When prompted press S to specify the location of

the driver.

6. Insert the driver diskette, then press Enter.

7. Select Silicon Image Sil 3x14 SATARaid Controller

for Windows XP, then press Enter.

8. Press Enter to finish driver installation, then follow

the on-screen instructions to complete the

installation.

Note: When the Software Installation warning pops

up, click Yes. And when the Hardware Installation

warning pops up, click Yes again. Our driver has been

thoroughly tested for stability and compatibility.

When Windows installation completes, go to SATARaid

GUI on page 22 and install the RAID monitoring utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation

and boot up to Windows.

2. At the Found New Hardware Wizard, insert the

driver CD, select Install the software automatically

(Recommended), and click Next.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Pas de commentaire

SIIG Serial ATA 4-Channel RAID Guide d'installation Page 20