SIIG USB Over IP Guide d'installation télécharger pdf (Page 8)

Network

Displays network status of the USB Over IP 1-Port and

provides access to network settings. From the Network

Setting section, you can Enable/Disable DHCP support

(default is Enabled), if your network does not have a

DHCP server or it is disabled enter an IP Address and

Subnet Mask (obtain from your network administrator),

or change the Server Name. A password is not needed

unless you have set a password.

Reset Device

Allows you to reboot the server. A password is not

needed unless you have set a password. An alternate

method to reset the server is via the reset button on the

back of the unit, use a pointed object such as the tip of a

pen and press the button for 5 seconds then release.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

SIIG USB Over IP Guide d'installation Page 8