SIIG PCI-2S+DOS Guide d'installation télécharger pdf (Page 9)

3. Type lspci -v and hit <enter>. This command

displays the CyberSerial Dual PCI's information

similar to the example listed below. This

information is needed to configure the serial ports.

- 02:0b.0 Serial controller: Oxford Semiconductor

Ltd EXSYS EX-41092 Dual 16950 Serial ....

- Subsystem: SIIG Inc: ....

- Flags: medium devsel, IRQ 9

- I/O ports at a000 [size=32]

- Memory at ed800000 (32-bit, ...) ....

- I/O ports at 9800 [size=32]

- Memory at ed000000 (32-bit, ...) ....

- Capabilities: [40] Power Management ....

4. Edit the startup file and add these two command

lines at end of the startup file.

- setserial /dev/ttyS2 port 0xa000 irq 9 uart 16950.

- setserial /dev/ttyS3 port 0xa008 irq 9 uart 16950.

Note: ttyS value, I/O port address and irq should

be different from one system to another. These

values should be based on the results you get from

steps 2 & 3.

5. Save the startup file and restart your system.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

SIIG PCI-2S+DOS Guide d'installation Page 9