SIIG SATA II PCIe RAID Guide d'installation télécharger pdf (Page 12)

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended), then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck

the other boxes, click Next, then click Next again.

5. If the Digital Signature Not Found message appears,

click Yes. Our driver has been thoroughly tested for

stability and compatibility.

6. Click Next, then Finish.

7. Repeat steps 2-6.

8. Click Yes to restart to complete the installation.

When Windows resumes, go to SATARaid5 GUI on

page 14 and install the RAID utility.

Windows XP/Server 2003

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the Floppy folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft's Windows installation procedure.

3. Restart the computer when prompted by Windows'

installation.

4. At the Windows Setup screen, press F6 to install the

RAID driver.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

SIIG SATA II PCIe RAID Guide d'installation Page 12