SIIG SATA II PCIe RAID Guide d'installation télécharger pdf (Page 5)

5. Follow the same instructions to connect the second

hard drive. Device connection is now complete.

Note: If it is your desire to monitor disk activity of

the Serial ATA hard drives, you may at this time

connect the hard disk LED of the system case to the

Hard Disk LED Pins on the Serial ATA controller.

Figure 4. Connecting HDD LED

6. Replace the computer cover and reconnect the

power cord. Go to RAID Arrays to configure the

RAID BIOS.

RAID Arrays

RAID Arrays are setup in the SATA II PCIe RAID's BIOS.

Find your RAID set from the table of contents.

Table of Contents

RAID 0 (striping) ............................................ page 6-7

RAID 1 (mirroring)......................................... page 7-8

Rebuilding a Failed Mirror Set .................... page 8-9

Deleting RAID Arrays ...................................... page 9

Resolving Conflicts......................................... page 10

Low Level Format........................................... page 10

Logical Drive Info ........................................... page 10

1 2 3 4 5 6 7 8 9 10 ... 23 24

Pas de commentaire

SIIG SATA II PCIe RAID Guide d'installation Page 5