SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 12)

Deleting RAID Arrays

1. As the BIOS boots press F3 when prompted to enter

the RAID BIOS.

2. Press F1 to dissolve a RAID set.

3. Enter the number of the RAID set to be deleted.

4. Answer Y to remove the RAID set.

5. Press ESC when finished to reboot.

Resolving Conflicts

If after a disk failure, the replacement disk was previously

part of a RAID set (or used in another system), it may have

conflicting metadata, specifically in reference to the drive

connection information. If so, this will prohibit the RAID

set from being either created or rebuilt, in order for the

RAID set to function properly, this old metadata must be

first overwritten with the new metadata. To resolve this,

press F4, the correct metadata, including the correct drive

connection information, will be written to the replacement

disk.

Software Installation

This section provides information on how to install the

UltraATA 133 PCI RAID drivers.

Table of Contents

Windows 98SE.............................................page 13-14

Windows ME...............................................page 14-15

Verify Windows 98SE.ME Installation ......... page 15

Windows NT 4.0 .........................................page 15-17

Verify Windows NT Installation ..............page 16-17

Windows 2000 .............................................page 17-18

Windows XP/Server 2003 .........................page 18-19

Verify 2000/XP/2003 Installation.................. page19

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 12