SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 4)

In any given RAID set, it's best to install the hard drives

on separate channels, either Master to Master or Slave to

Slave. For example, if you are setting up a RAID set with

two hard drives, install the first drive on IDE1 as Master

and the second on IDE2 as Master. Use the same concept

for multiple hard drives.

Note: Only the 40-pin/80-wire UltraATA cable can

achieve hard disk UDMA 133 performance. When

attaching only two hard drives it is recommended that

they be connected on separate IDE channels.

1. If you plan to install two hard disk drives on the

IDE1 channel, make sure to configure one drive as

Master and the drive as Slave. Follow the hard drive

manufacturer’s instructions for the correct jumper

setting. The same rule must be followed for

connecting hard disk drives to the IDE2 channel.

2. Attach one end of the included Ultra ATA cable to

the IDE1 connector on the board. Make sure pin 1

on the cable (indicated by the stripe) matches pin 1

on the IDE1 connector.

Pin 1

Figure 2. Connecting the Cable to the On-Board Connector

Stripe

1 2 3 4 5 6 7 8 9 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 4