SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 3)

Hardware Installation

General instructions for installing the card are provided

below. Since the design of computer cases and

motherboards vary, refer to your computer’s reference

manual for further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer’s case for a few

seconds. Avoid any contact with internal parts and

handle cards only by their external edges.

1. Turn OFF the power to your computer and any

other connected peripheral devices.

2. Unplug the power cord from the back of the

computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

6. Replace the slot bracket's holding screw to secure

the card.

Device Connection

The UltraATA 133 PCI RAID is a dual channel Ultra ATA

133 controller that supports up to four IDE hard disk

drives. To achieve maximum performance and

compatibility we suggest using identical hard drives in

building your RAID sets.

1 2 3 4 5 6 7 8 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 3