SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 13)

Windows 98SE

For A New Installation

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft procedures to install Windows

98SE accordingly.

3. Once Windows has installed and booted, right click

My Computer and click Properties. Select Device

Manager tab.

4. Double click PCI RAID controller listed under

Other Devices.

5. Select Driver tab, then click Update Driver button.

6. Insert the driver diskette, then click Next.

7. Select Search for the better driver ... and click Next.

8. Check Floppy disk drives, uncheck the other boxes,

then click Next. Click Next again, then Finish.

9. Remove the driver diskette, close all open Windows,

then restart Windows to complete the installation.

When Windows resumes, go to Medley GUI on page 20

and install the RAID monitoring utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At the Add New Hardware Wizard, click Next to

continue.

3. Select Search for the best driver for your device,

then click Next.

4. Insert the driver diskette, check Floppy disk drives,

uncheck the other boxes, then click Next.

5. Click Next, then Finish.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 13