SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 6)

RAID 0 (Striping)

This RAID array to be used on New/Blank hard drives.

Striping will destroy existing data on the hard drive.

For Manual Setup

1. As the BIOS boots press F3 when prompted to enter

the RAID BIOS.

2. At the next screen press F2 to form a RAID set.

3. Press F1 to create RAID 0.

4. Choose the chunk size to be used in the RAID set

(64 is recommended).

5. Choose the number of hard drives in your stripe set.

6. Assign the hard drives to be used. For optimal

performance, alternate hard drives from seperate

IDE channels.

7. After all hard drives are entered, press Y to create

the RAID set.

8. Press ESC to exit the RAID BIOS and boot your

computer.

9. Continue with Fdisk and Format steps as if you are

installing a conventional hard drive.

For Auto Setup

1. As the BIOS boots press F3 when prompted to enter

the RAID BIOS.

2. Press F2 to create a RAID set.

3. Press F1 to create a Stripe set.

4. Press A for Auto Setup.

5. Enter the number of hard drives in the stripe set.

6. Press Y to accept the configuration.

7. Configure another RAID set or press ESC to reboot.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 6