SIIG UltraATA 133 PCI Guide d'installation télécharger pdf (Page 16)

9. Screen 5, Windows NT Setup, make sure driver

diskette is in floppy drive and press Enter.

10. Screen 6, Windows NT Setup, highlight Silicon

Image Ultra-133 Medley ATA RAID Controller

and hit Enter to load driver.

11. Screen 7, Windows NT Setup, the UltraATA 133

driver, Silicon Image Ultra-133 Medley ATA RAID

Controller should be listed. Hit Enter. Setup will

load drivers.

12. Follow on-screen instructions to complete setup for

your NT version.

When Windows installation completes, go to Medley

GUI on page 20 and install the RAID monitoring utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows NT.

2. Double click My Computer/Control Panel/SCSI

Adapters, then click on the "Drivers" tab.

3. Select Add… then Have Disk....

4. Insert the driver diskette, type in A:, then click OK.

5. Highlight Silicon Image Sil 0680 Ultra-133 Medley

ATA RAID Controller and click OK.

6. Remove the driver diskette, close all open Windows,

then restart NT to complete the installation.

When Windows resumes, go to Medley GUI on page 20

and install the RAID monitoring utility.

To Verify Installation In Windows NT 4.0:

1. Go to Start / Settings / Control Panel, double click

SCSI Adapters icon.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Pas de commentaire

SIIG UltraATA 133 PCI Guide d'installation Page 16